Use precautions:
1. when the nebulizer is working properly, please do not put your hands above the spray chamber of the nebulizer to prevent ultrasonic injury.
2. The atomizer must be in water to work properly. Please put it in water before using, then turn on the power supply, and ensure that the surface of the atomizer is in a water state, so as not to damage the atomizer.
3. Disconnect the power supply before stopping using the atomizer, and then remove the atomizer from the water.
4. When using this nebulizer, please choose a power supply with output power greater than 350W and output voltage of DC45+5V. The power supply should isolate the fog to avoid the fog getting into the power circuit board, short circuit and burn off the power supply.
5. When multiple atomizers are used in the same container, they should be equipped with separate power supply. They can not be connected with multiple atomizers by a single power supply. Attention should be paid to the interconnection of the shell of each atomizer so as to prevent electrical corrosion during operation.
6. The fog produced by the atomizer must be forced to be discharged by a fan, and the plane space of 350CM2 is reserved for each group of atomizers, so as to avoid excessive water temperature and shorten the service life of the atomizer.
7. The atomizer is not suitable for atomizing corrosive liquids, so as to avoid damaging the metal shell and atomizing sheet of the atomizer.
8. Do not damage the water level induction switch during installation, so as not to cause the atomizer out of control due to the failure of the water level switch. When the water level switch is damaged, it should stop using, otherwise the atomizer will be dry burned and further damaged. At this time, it needs professional maintenance personnel to repair it before it can be used.
| Type | Voltage | Size | Power | Water Rate |
| ARS-WHHN230W | 48V | 253*91*70MM | 230 | 4.5KG/H |
